LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> RV Cutaway 6.8 S >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control - Gasoline Engines >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 retaining nuts.

    • Tighten to 7 Nm (62 lb-in).
  2. Connect the 3 PCM electrical connectors.
    3. NOTE: If the PCM or Instrument Cluster (IC) is replaced (or both), the parameters must be reset in both modules or the vehicle will experience a Passive Anti-Theft System (PATS) no-start. This will occur even if the vehicle is not equipped with PATS  . For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  3. Restore the module configurations for the IC  module and the PCM. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  4. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals