Removal And Installation

WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.

NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in SUPPLEMENTAL RESTRAINT SYSTEM article.
Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
Disconnect the traction control switch electrical connector.
Disengage the locking tangs and remove the traction control switch from the instrument panel center finish panel.

Fig 1: Identifying Locking Tangs

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
Repower the SRS. For additional information, refer to SRS Depowering and Repowering in SUPPLEMENTAL RESTRAINT SYSTEM article.