Input Shaft: Disassembly

WARNING: This page is about a different car, the 2004 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Handle the synchronizer ring and synchronizer cone with care.

Using a puller, remove the bearing (transaxle end).
1. Install the snap-ring.
2. Install a standard puller underneath the snap-ring and pull off the bearing.
  
  Fig 1: Removing Bearing (Transaxle End)
  Courtesy of FORD MOTOR CO.
Remove the bearing (clutch end).

Fig 2: Removing Bearing (Clutch End)
Courtesy of FORD MOTOR CO.