LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Probe Base, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Removal & Installation >> CLOCKSPRING >> Installation

Removal & Installation: CLOCKSPRING: Installation

  1. Ensure vehicle front wheels are in straight-ahead position, and steering column shaft alignment mark is at 12 o'clock position. Align clockspring (contact assembly) to column shaft and mounting bosses. Slide clockspring onto shaft. Install 3 retaining screws and tighten to specification. See TORQUE SPECIFICATIONS  .
  2. Remove tape strips. If new clockspring is being installed, remove Red plastic locking insert. Route clockspring wiring down column assembly and connect to column wiring harness. Install steering column lower shroud and lower instrument panel cover. Install lower right and left moldings on instrument panel.
  3. Install steering wheel and driver-side air bag module. Activate SRS. Ensure system is functioning properly. See SYSTEM OPERATION CHECK  .
scientia non olet · About LEMON Manuals