LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Probe GL, Standard >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Self-Adjusting Assembly >> Removal

Self-Adjusting Assembly: Removal

  1. Disconnect negative battery cable. Remove steering wheel using Steering Wheel Puller (T67L-3600-A). Remove lower dash panel section to the left of steering column.
  2. Remove shrouds from steering column. Disconnect brake light switch and master cylinder push rod from brake pedal. Rotate clutch quadrant forward and unhook clutch cable. Allow quadrant to slowly swing rearward.
  3. Remove bolt holding brake pedal support bracket (lateral brace) to left side of vehicle. Disconnect all electrical connectors leading to steering column. Remove 4 nuts holding steering column to brake pedal support bracket and lower steering column to the floor.
  4. Remove 4 booster nuts that hold brake pedal support bracket to dash panel. Remove bolt that holds bracket to underside of instrument panel. Remove bracket assembly from vehicle.
  5. Remove clutch pedal shaft nut and clutch pedal. Slide self-adjusting mechanism out of brake pedal support bracket. Remove self-adjusting mechanism shaft bushings from both sides of brake pedal support bracket and replace if worn.
scientia non olet · About LEMON Manuals