Removal & Installation: Clutch: Installation
- Clutch disc must be installed with flatter side toward flywheel as marked.
- Position clutch disc and align dowel pins of pressure plate onto flywheel. Start pressure plate bolts but do not tighten to flywheel. Install Clutch Plate Aligner (T81P-7550-A) into crankshaft pilot bearing.
- With clutch aligned, tighten pressure plate bolts in a crisscross sequence until they are just seated. Tighten cover bolts to specifications and remove clutch aligner.
- Before installation of transaxle, lubricate contact surfaces of transaxle input shaft, release bearing and release fork pivot point. Install new circlips on ends of half-shafts. To complete installation of transaxle, reverse removal procedure.
FLYWHEEL SPECIFICATIONS
| Application | In. (mm) |
|---|---|
| Runout Limit | .008 (.20) |
| Material Removal Limit | .02 (.5) |