LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500X Pop >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Arm, Lower Control >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0163522Courtesy of CHRYSLER GROUP, LLC
  1. Position the lower control arm (1) in the vehicle, and hold into position with hydraulic jack.
  2. Install the lower control arm to cradle front bolt (2), and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0165903Courtesy of CHRYSLER GROUP, LLC
  3. Install the lower control arm to cradle rear bolt (1), and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0163717Courtesy of CHRYSLER GROUP, LLC
  4. Check the integrity of the lower ball joint boot ring (1).
    GC0165848Courtesy of CHRYSLER GROUP, LLC
  5. Install the lower control arm to knuckle bolt (1), and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  6. Install the outer tie rod end to the knuckle. Refer to TIE ROD, STEERING, INSTALLATION .
  7. Install the front hub nut. Refer to HUB AND BEARING, INSTALLATION  .
  8. Install the front stabilizer bar links. Refer to LINK, STABILIZER BAR, INSTALLATION  .
  9. Install the lower load beam Refer to LOAD BEAM, LOWER, INSTALLATION .
  10. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  11. Install the front recovery hook if equipped.
  12. Install the tire and wheel assembly. Refer to INSTALLATION .
  13. Perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
  14. Install the under body splash shield. Refer to BELLY PAN, INSTALLATION and BELLY PAN, SIDE, INSTALLATION .
scientia non olet · About LEMON Manuals