Installation - GPEC Controller (2.4L)

Fig 1: GPEC CONTROLLER MOUNTING

Courtesy of CHRYSLER LLC

1 - Bracket

2 - PCM

3 - Bolts

NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER (VIN) AND THE VEHICLES ORIGINAL MILEAGE. IF THIS STEP IS NOT DONE, A DIAGNOSTIC TROUBLE CODE (DTC) MAY BE SET.

Install PCM (2) to bracket (1) with 4 bolts (3).

Fig 2: GPEC CONTROLLER
Courtesy of CHRYSLER LLC

1 - Connectors

2 - PCM
Install and lock the 2 electrical connectors (1) to the PCM (2).
Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
Use the scan tool to reprogram new PCM with vehicles original Identification Number (VIN) and original vehicle mileage.