Right-Hand Drive

Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.

Fig 1: Solenoid Valve Seal
Courtesy of CHRYSLER LLC

1 - SEAL

2 - SOLENOID VALVE STEM
If the seals (1) on the solenoid valve stems (2) are not new, replace them all. Each of the solenoid valve stem seals must be new to keep out moisture and debris;do not reuse solenoid valve stem seals.

Fig 2: Internal Pump Connector O-Ring
Courtesy of CHRYSLER LLC

1 - O-RING

2 - O-RING MOUNTING GROOVE
Replace the pump/motor connector O-ring (1) if it is not new. Be sure the O-ring is properly seated in the mounting groove (2).

Fig 3: ABM ASSEMBLY TO HCU
Courtesy of CHRYSLER LLC

1 - ABM

2 - HCU

3 - SOLENOID VALVE STEM
Align components and install the ABM (1) on the HCU (2).

Fig 4: ABM Mounting Screws
Courtesy of CHRYSLER LLC

1 - MOUNTING SCREWS

2 - ABM
Install the four screws (1) attaching the ABM (2) to the HCU. Tighten the mounting screws to 2 N.m (17 in. lbs.).

Fig 5: WIRING HARNESS CONNECTOR AT ABM
Courtesy of CHRYSLER LLC

1 - ABM (PART OF ICU)

2 - WIRING HARNESS CONNECTOR

CAUTION: Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
Install the air inlet hose (1) between the air cleaner housing and engine.
Connect the negative cable on the battery negative post.
Hook up the scan tool to initialize the ABM and perform the following:
1. Clear any faults.
2. Perform the ABS Verification Test and road test the vehicle. Refer to DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure