LEMON Manuals: Even more car manuals for everyone
Home >> Daewoo >> 2000 >> Lanos SE, Standard >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Transaxle Assembly >> Installation

Transaxle Assembly: Installation

NOTE: Flywheel retaining bolts are tightened to crankshaft in 3 steps. They are tightened using an initial torque specification, plus 2 torque-turn steps.
  1. If flywheel was removed from engine, install flywheel. Tighten flywheel-to-crankshaft bolts to 25 ft. lbs. (35 N.m) PLUS 30 degrees, PLUS and additional 15 degrees. Install clutch on flywheel. See CLUTCH DISC & COMPONENTS  . Support transaxle with a transaxle support jack. Install transaxle by inserting transaxle input shaft into clutch disc and sliding transaxle sideways into engine block. Install lower transaxle-to-engine bolts. Tighten lower transaxle-to-engine bolts to 55 ft. lbs. (75 N.m).
  2. Install left rear transaxle support bracket and bolts. Tighten left rear transaxle support bracket bolts to 66 ft. lbs. (90 N.m). Install left front transaxle support bracket and bolts. Tighten left front transaxle support bracket bolts to 44 ft. lbs. (60 N.m).
  3. Install flywheel inspection cover and flywheel inspection cover bolts. Tighten flywheel inspection cover bolts to 62 INCH lbs. (7 N.m). Install both of drive axle shafts. See appropriate article in DRIVE AXLES. Lower vehicle.
  4. Install upper transaxle-to-engine bolts. Tighten upper transaxle-to-engine bolts to 55 ft. lbs. (75 N.m). Remove engine support fixture J-28467-B. Install clutch release cylinder bracket and clutch release cylinder bracket bolts. Tighten clutch release cylinder bracket bolts to 55 ft. lbs. (75 N.m).
scientia non olet · About LEMON Manuals