Removal And Installation: AWD: Installation

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

CAUTION:

Before tightening the CKP sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.

Lubricate the Crankshaft Position (CKP) sensor O-Ring with clean engine oil.
Install the sensor into the engine block with a slight rocking and twisting action.
Install the CKP sensor bolt and tighten to the proper specifications. Refer to: FUEL INJECTION, GAS, TORQUE SPECIFICATIONS .