Module, Radio Frequency (RF Hub): Removal

WARNING: This page is about a different car, the 2017 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

The Remote Frequency Hub (RF Hub) Module Assembly consists of a harness connector and two pushpin.

The control module is located behind the rear cab panel beneath the rear sliding glass assembly. Note that the remote start antenna is plugged directly into the RF Hub.

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate negative battery cable.
Flip the left rear seat cushion.
Remove the left rear seat rear inboard bolt with seat belt buckle. Refer to BUCKLE, SEAT BELT, REMOVAL .
Remove left rear seat. Refer to SEAT, FRONT CENTER, REMOVAL .
Remove left rear child seat tether. Refer to ANCHOR, CHILD SEAT, REMOVAL .
Remove rear left side rear cab trim panel push pins to remove panel. Refer to PANEL, CAB BACK TRIM, REMOVAL .
Disconnect coax cable electrical connector at the RF hub (1).
Disconnect harness (2) and remove the RF Hub retainers. (3)