LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1438 (Electronic Control Modules (Service Information) - 1500) >> Module, HVAC >> Installation

Module, HVAC: Installation

WARNING: This page is about a different car, the 2017 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wire harness connector to the Heating, Ventilation, and Air Conditioning (HVAC) module.
  2. Position the HVAC module to the instrument panel, through the glove box opening and engage the module retaining screws to the slots on instrument panel.
    GC0154539Courtesy of CHRYSLER GROUP, LLC
  3. Tighten the two screws (1) that secure the HVAC module (2) to the instrument panel to 2 N.m (17 in. lbs.).
  4. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  5. Install the right side instrument panel end cap.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  7. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals