Module, Occupant Restraint Controller: Installation: Installation

WARNING: This page is about a different car, the 2009 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating ORC

Courtesy of CHRYSLER LLC

Connect the two ORC connectors (3, referred to as C1 and C2 in the diagnostic information and wiring) and ensure that all locking tabs are engaged.

Fig 2: GROUND STRAP
Courtesy of CHRYSLER LLC
Position ORC (arrow pointing forward) in the console floor bracket, replace ground eyelet (1), and attach the screws (2) and tighten to 10.5 N.m (95 in. lbs.).
NOTE: Place the ground eyelet (1) on the passenger side front screw (2) when reattaching the ORC.
Install center console assembly. Refer to Body/Interior/CONSOLE, Center - Installation .
WARNING: Do not connect the battery negative cable. See Restraints - Diagnosis and Testing . Serious or fatal injury may result if the system test is not performed first.