LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (3.5L) >> Cylinder Head >> Removal

Cylinder Head: Removal

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform fuel pressure release procedure before attempting any repairs.  . (Refer to FUEL SYSTEM PRESSURE RELEASE ).
  2. Disconnect negative cable from remote battery jumper terminal.
  3. Drain cooling system. (Refer to STANDARD PROCEDURE ).
  4. Remove crankshaft vibration damper. (Refer to REMOVAL ).
  5. Remove front timing belt covers. (Refer to REMOVAL ).
  6. Remove camshaft sprockets. (Refer to REMOVAL ).
  7. Remove upper and lower intake manifold. (Refer to appropriate procedure).
  8. Remove V-Band clamp(s) at exhaust manifold to catalytic converter pipe connection.
    NOTE: Do not reuse V-Band Clamp.
  9. Remove rear timing belt cover to cylinder head fasteners (Fig 1). Remove the rear covers.
    Fig 1: Identifying Rear Timing Belt Cover Bolts
    G02709714Courtesy of DAIMLERCHRYSLER CORP.
  10. The right side rear timing belt cover has O-rings to seal the water pump passages to cylinder block (Fig 2). Do not reuse O-rings.
    Fig 2: Identifying Right Side Timing Belt Cover Water Pump O-Rings
    G02709715Courtesy of DAIMLERCHRYSLER CORP.
  11. Remove cylinder head bolts in REVERSE of tightening sequence (Figure).
  12. Remove cylinder head(s).
scientia non olet · About LEMON Manuals