LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1998 >> Sebring LXi >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments - 2.5L Engine VIN [N] >> Throttle Position Sensor >> V6 Throttle Position Sensor

V6 Throttle Position Sensor

NOTE: Throttle Position (TP) sensor is nonadjustable. Use following procedure to check TP sensor calibration. For complete testing of TP sensor and wiring circuit, see appropriate TESTS W/CODES article.
  1. Ensure ignition is off. Disconnect electrical connector from TP sensor mounted on throttle body. Using ohmmeter, check resistance between terminals No. 1 and 3 on TP sensor. Replace TP sensor if resistance is not 3500-6500 ohms.
  2. Using ohmmeter, check resistance between terminals No. 2 and 3 on TP sensor while slowly moving throttle from idle to full throttle. Replace TP sensor if resistance does not change smoothly while opening and closing the throttle.
scientia non olet · About LEMON Manuals