LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1996 >> LHS >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Self-Diagnostics Tests >> Test 6E: Right Rear Sensor Circuit

Test 6E: Right Rear Sensor Circuit

NOTE: Perform TEST 6A: SENSOR CIRCUIT  before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION  . For wiring diagram, see WIRING DIAGRAMS  .
  1. Inspect Right Rear (RR) Wheel Speed Sensor (WSS) and connector for damage, or for connector being disconnected. If RR WSS and connector are okay, go to next step. If RR WSS or connector are damaged, or connector was disconnected, repair or reconnect connector as necessary. Perform TEST VER-1A: VERIFICATION TEST  .
  2. Turn ignition off. Disconnect RR WSS. Inspect connector for pushed-out terminals, damaged terminals or miswired terminals. If all terminals are okay, go to next step. If terminals are defective, repair as necessary. Perform TEST VER-1A: VERIFICATION TEST  .
  3. Using scan tool in ohmmeter mode, check resistance across RR WSS. If resistance is 800-1400 ohms, go to next step. If resistance is not as specified, replace RR WSS. Perform TEST VER-1A: VERIFICATION TEST  .
  4. Check resistance between ground and either RR WSS terminal. If resistance is 15,000 ohms or more, go to next step. If resistance is less than 15,000 ohms, replace RR WSS. Perform TEST VER-1A: VERIFICATION TEST  .
  5. Disconnect CAB connector. Inspect CAB connector and terminals for damage. Repair connector and terminals as necessary. Perform TEST VER-1A: VERIFICATION TEST  . If connector and terminals are okay, go to next step.
  6. Check resistance between ground and RR WSS connector terminal No. 2 (Yellow wire). If resistance is 15,000 ohms or more, go to next step. If resistance is less than 15,000 ohms, repair short to ground in Yellow wire between CAB and RR WSS. Perform TEST VER-1A: VERIFICATION TEST  .
  7. Check resistance between ground and RR WSS connector terminal No. 1 (Yellow/Dark Blue wire). If resistance is 15,000 ohms or more, go to next step. If resistance is less than 15,000 ohms, repair short to ground in Yellow/Dark Blue wire between CAB and RR WSS. Perform TEST VER-1A: VERIFICATION TEST  .
  8. Connect a jumper wire between ground and RR WSS connector terminal No. 2 (Yellow wire). Check resistance between CAB connector terminals No. 11 (Black wire) and No. 29 (Yellow wire). If resistance is less than 10 ohms, go to next step. If resistance is 10 ohms or more, repair open Yellow wire between CAB and RR WSS. Perform TEST VER-1A: VERIFICATION TEST  .
  9. Move jumper wire from RR WSS terminal No. 2 (Yellow wire) to RR WSS connector terminal No. 1 (Yellow/Dark Blue wire). Check resistance between CAB connector terminals and No. 11 (Black wire) and No. 31 (Yellow/Dark Blue wire). If resistance is less than 10 ohms, replace CAB. Perform TEST VER-1A: VERIFICATION TEST  . If resistance is 10 ohms or more, repair open Yellow/Dark Blue wire between CAB and RR WSS. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals