Removal & Installation
- Raise vehicle and remove wheel and tire assembly. Remove screw and clip securing sensor to fender shield. Carefully pull sensor assembly grommet from fender shield. Unplug connector from harness. Remove retainer clip from bracket on strut. Remove grommets from retainer brackets.
- Remove sensor retaining screw. Carefully remove sensor from steering knuckle. If sensor is frozen, DO NOT use pliers. Use a hammer and punch to tap edge of sensor ear, rocking sensor from side to side until free.
- To install, reverse removal procedure. Coat sensor with high-temperature multipurpose grease before installing. Tighten sensor screw to 60 INCH lbs. (7 N.m). There is no air gap adjustment.
CAUTION:
Proper installation of wheel speed sensor cables is critical to system operation. Ensure cables are installed in retainers. Failure to install cables in retainers may result in contact with moving parts and/or over-extension of cables, causing an open circuit.