Propeller Shaft Alignment: Measurement

The following measurements are made with an inclinometer tool (C-4224). Car must be supported by wheels or front suspension lower control arms and rear axle housing. Do not use frame contact hoist. Car should be reasonably level, fuel tank full, and free of extra weight such as luggage or tools. Rotate propeller shaft so that cross and roller bushings on axle and transmission yokes are facing downward. Install inclinometer tool by placing magnet on universal bushing of axle or transmission. Work propeller shaft contact shoe up against shaft so both front and rear tabs contact bottom of propeller shaft. Make sure no bending strain is applied to magnet or measuring arm. Note inclinometer reading and adjust as necessary.