LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2025 >> Traverse Z71 >> Repair and Diagnosis >> Body & Frame >> Towing Systems >> TRAILERING Systems >> Diagnostic Information and Procedures >> DTC B100C >> Circuit/System Testing

Circuit/System Testing

  1. Ignition ON/vehicle in service mode, exterior lamps OFF.
  2. Connect a test lamp between the trailer backup lamp Fuse F30RA and ground.
    3. NOTE:

    Scan tool control functions can be found under the K219 Lighting Control Module.

  3. Verify the test lamp turns ON and OFF when commanding the Trailer Backup Lamps ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Test the ground circuit at the X53A Body Wiring Harness Junction Block - Rear for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the ground circuit or ground connection.
      • Go to next step: If an open/high resistance is not found.
    2. Test control circuit 38 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    3. Test control circuit 38 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    4. Replace the X53A Body Wiring Harness Junction Block - Rear.
    • If the test lamp is always ON 
    1. Test control circuit 38 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
    2. Replace the X53A Body Wiring Harness Junction Block - Rear.
    • Go to next step: If the test lamp turns ON and OFF 
  4. Replace the K219 Lighting Control Module.
scientia non olet · About LEMON Manuals