Installation Procedure
WARNING: This page is about a different car, the 2023 GMC Savana 3500, 2023 GMC Savana 2500, 2023 Chevrolet Express 3500, and 2023 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Plug the wheel speed sensor bore to prevent debris from entering the wheel hub and bearing.
- Clean the mounting surface on the wheel hub to remove any corrosion and debris.
- Apply a light coat of wheel speed anti-corrosion grease to the wheel speed sensor and mounting pad on the wheel hub and bearing assembly. Adhesives, Fluids, Lubricants, and Sealers
- Remove the plug from the wheel speed sensor bore.
Wheel Speed Sensor (1) - Install
- CAUTION:
Refer to Fastener Caution .
Wheel Speed Sensor Bolt (1) - Install and tighten 18 N.m (13 lb ft)
Clip (1) - Secure
Clip (1) - Secure
Clip (1) - Secure
Electrical Connector (1) - Connect
Front Brake Rotor (1) - Install - Front Brake Rotor Replacement (JH6) , or Front Brake Rotor Replacement (JH9)
- Install the tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Perform the diagnostic system check. Diagnostic System Check - Vehicle