LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Front Door Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Door Module
    GM1531780Courtesy of GENERAL MOTORS CORP.
  1. Position the front door hardware module to the front door.
  2. Align the modular locator pin (1) into the 4-way locating hole (2) in the door structure.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the front door module screws and tighten, in sequence as shown, to 10 N.m (89 lb in)  .
    4. Fig 2: Identifying Door Latch Screws
    GM1480547Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 (1) door to latch (2) screws and tighten, in sequence as shown, to 10 N.m (89 lb in)  .
  5. Install the outside handle including the rod connect. Refer to Front Side Door Outside Handle Replacement .
  6. Remove the tape on the glass and install the glass to the door module sash.
  7. Load the door wiring harness through the hinge face and attach to the body harness.
  8. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  9. Install the front door speaker. Refer to Radio Front Speaker Replacement .
  10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals