LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Rear Suspension System) >> Repair Instructions >> Spindle Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spindle Rod, Knuckle, And Bolt
    GM803927Courtesy of GENERAL MOTORS CORP.
  1. Install the spindle rod (5) to the vehicle.
  2. Install the spindle rod (5) to the knuckle (8).
    NOTE: Refer to Fastener Notice .
  3. Install the spindle rod to knuckle bolt (4) and nut.

    Tighten:  Tighten the nut to 150 N.m (110 lb ft).

    Fig 2: View Of Spindle Rod And Rear Suspension Support Bolt
    GM614974Courtesy of GENERAL MOTORS CORP.
  4. Install the spindle rod to the rear suspension support.
  5. Install the bolt (1) and nut to the rear suspension support.

    Tighten:  Tighten the bolt to 135 N.m (100 lb ft).

  6. Install the rear suspension support. Refer to Support Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Adjust the wheel toe angle. Refer to Wheel Alignment Specifications in Wheel Alignment.
scientia non olet · About LEMON Manuals