Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rotating Temperature Knob

GM893465

Courtesy of GENERAL MOTORS CORP.

Rotate the temperature knob to the full hot position.
Install the cable eyelet onto the HVAC control assembly pin and install the cable housing flag into the slot in the HVAC control assembly until it engages the locking tab.

Fig 2: Identifying HVAC Control Assembly Electrical Connectors

GM893931

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the HVAC control assembly.

Fig 3: Removing/Installing HVAC Control Assembly-To-Instrument Panel Screws

GM893371

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws that secure the HVAC control assembly to the I/P.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 4: Removing/Installing Radio

GM893367

Courtesy of GENERAL MOTORS CORP.

Connect the radio electrical and antenna connectors.

Fig 5: Removing/Installing Radio Mounting Screws

GM893365

Courtesy of GENERAL MOTORS CORP.

Install the radio mounting screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 6: Removing/Installing Radio Bezel Trim Plate

GM893362

Courtesy of GENERAL MOTORS CORP.

Install the radio trim bezel.