LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Classic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Lower Control Arm Bushings Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of J 21474-27, J 41211-1, J 41211-3 & J 21474-4 In Order Of Assembly
    GM534383Courtesy of GENERAL MOTORS CORP.
  1. Insert the rear bushing into the control arm.
    2. IMPORTANT: ApplyJ 23444-A  or equivalent to the threads of the J 21474-27 . See Special Tools .
  2. Assemble the following bushing installation tools as shown:
  3. Tighten the J 21474-4  until the rear bushing is fully seated in the control arm. See Special Tools .
  4. Disassemble the bushing installation tools.
    5. Fig 2: View Of J 21474-19, J 41397-1A, J 41397-2A & J 21474-18 In Order Of Assembly
    GM534373Courtesy of GENERAL MOTORS CORP.
  5. Lubricate the outer casing of the front bushing.
  6. Insert the front bushing into the control arm.
  7. Assemble the following bushing installation tools as shown:
    • J 21474-19
    • The remover/installer from the J 41397  . See Special Tools .
    • The receiver from the J 41397  . See Special Tools .
    • J 21474-18
  8. Tighten the J 21474-19 until the front bushing is fully seated in the control arm.
  9. Disassemble the bushing installation tools.
  10. Install the lower control arm. Refer to Lower Control Arm Replacement .
scientia non olet · About LEMON Manuals