LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Control System - Self-Diagnostics - 4.6L) >> System Tests >> Scan Tool Does Not Power Up >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2001 Cadillac Seville, 2001 Cadillac Eldorado, and 2001 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for an open or short to ground in Orange wire between ground and terminal No. 16 at Data Link Connector (DLC). See Figure. If an open or short to ground does not exist, go to next step. If an open or short to ground exists, repair wiring harness as necessary. After repair is complete, perform POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. Check for an open in Black wire between ground and terminal No. 4 at DLC. If an open does not exist, go to next step. If an open exists, repair wiring harness as necessary. After repair is complete, perform POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  3. Inspect terminals No. 4 (Black wire) and No. 16 (Orange wire) at DLC for poor connections. If connections are okay, go to next step. If poor connections are found, repair as necessary. After repair is complete, perform POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  4. Scan tool may be faulty. See scan tool manufacturer's user guide. Obtain a known-good scan tool. Perform POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals