LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Engine Controls And Fuel - 4.4L - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal
    GM931700Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
  2. Install the accelerator pedal mounting bolts (1).

    Tighten:  Tighten the accelerator pedal mounting bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Accelerator Pedal Sensor Module Electrical Connector
    GM1252542Courtesy of GENERAL MOTORS CORP.
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Check for correct carpet fit under the accelerator pedal.
  5. Install the left I/P on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals