LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper System Module Replacement (RHD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Wiper Module Assembly
    GM783105Courtesy of GENERAL MOTORS CORP.
  1. Place the wiper motor module into the vehicle.
  2. Connect the wiper motor module electrical connector (4).
  3. Align the wiper module locator hole (7) to the pin located inside rail of the driver side fender.
  4. Align the locator hole (6) to the hole in the pillar flange.
    5. NOTE: Refer to Fastener Notice .
  5. Install the outer bolt (5) first.

    Tighten:  Tighten the outer bolt first to 10 N.m (89 lb in).

  6. Install the center bolt (3) second.

    Tighten:  Tighten the center bolt to 10 N.m (89 lb in).

    7. Fig 2: Removing & Installing Air Inlet Panel-To-Cowl Panel Screws (RHD)
    GM783104Courtesy of GENERAL MOTORS CORP.
  7. Install the air inlet grille (1, 3). Refer to Air Inlet Grille Panel Replacement (RHD) .
  8. Install the wiper arm assemblies. Refer to Wiper Arm Replacement (RHD) .
  9. Install the wiper motor fuses to the underhood fuse block.
scientia non olet · About LEMON Manuals