LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Seat System) >> Repair Instructions >> Seat Control Module Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat control module on to seat adjuster.
    2. Fig 1: View Of Seat Control Module Electrical Connector & Retaining Nuts
    GM1261005Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat control module nuts (2).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Connect the electrical connector (2) to the control module.
  4. Install the seat cushion frame. Refer to Seat Cushion Frame Replacement - Rear No. 2 .
  5. Calibrate the seat. Refer to Power Folding Seat Calibration .
scientia non olet · About LEMON Manuals