Case Extension Housing: Removal
- Raise and support the vehicle. Support the vehicle with safety stands. Remove the right front drive axle. See appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
- Remove the wiring harness. Remove the bolts securing the front transaxle brace to the transaxle and right cylinder head. See TRANSAXLE BRACE
.
- Remove the right transaxle to engine brace. Remove the vehicle speed sensor. See VEHICLE SPEED SENSOR
. Remove the ground wire from the case.
- Remove the following parts from the case extension:
- Five 13-mm bolts (128 and 129).
- One 15-mm stud (127).
- Remove the case extension (134) and the seal (126). See Fig 1
. Remove the roller thrust bearing (132) and the selective washer (133).
- Remove the 8-mm scavenge tube bolt (15). See Fig 2
. Remove the scavenge tube by prying on the differential. Remove the scavenge tube seal. See Fig 3
.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.