Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Oil Cooler Gasket |
| Thermostat Bypass Pipe Gasket |
| Thermostat Housing Gasket |
| Turbocharger Coolant Feed Pipe Copper Washer |
| Turbocharger Coolant Feed Pipe Gasket |
| Turbocharger Coolant Return Pipe Copper Washer |
| Water Outlet Seal |
| Water Pump Gasket |
| Water Pump Inlet Pipe Seal |
| Water Pump Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Engine Coolant Air Bleed Pipe Bolt (LTG) | 10 N.m (89 lb in) |
| Engine Coolant Fan Shroud Bolt (LEA) | 10 N.m (89 lb in) |
| Engine Coolant Temperature Sensor (LEA) | 20 N.m (15 lb ft) |
| Engine Coolant Thermostat Bolt (LEA) | 10 N.m (89 lb in) |
| Engine Coolant Thermostat Housing Bolt (LEA, LTG) | 10 N.m (89 lb in) |
| Radiator Drain Cock | 2 N.m (18 lb in) |
| Radiator Lower Bracket Bolt | 22 N.m (16 lb ft) |
| Radiator Upper Bracket Bolt | 22 N.m (16 lb ft) |
| Thermostat Bypass Pipe Bolt (LTG) | 10 N.m (89 lb in) |
| Turbocharger Coolant Feed Pipe Banjo Bolt (LTG) | 35 N.m (26 lb ft) |
| Turbocharger Coolant Feed Pipe Fastener (LTG) | 10 N.m (89 lb in) |
| Turbocharger Coolant Return Pipe Banjo Bolt (LTG) | 35 N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Fastener (LTG) | 10 N.m (89 lb in) |
| Water Outlet Bolt (LTG) | 12 N.m (106 lb in) |
| Water Pump Fastener (LTG) | |
|
25 N.m (18 lb ft) |
|
25 N.m (18 lb ft) |