Approximate Fluid Capacities

The following approximate capacities are given in US English and metric conversions. See Fluid and Lubricant Recommendations for more information. All capacities are approximate. When adding, be sure to fill to the approximate level as recommended in this manual. Recheck fluid level after filling.

Application	Specification
Application	Metric	English
Cooling System
2.4L L4 Engine	9.6 liters	10.1 quarts
3.6L V6 Engine	7.1 liters	7.5 quarts
Engine Oil with Filter
2.4L L4 Engine	4.7 liters	5.0 quarts
3.6L V6 Engine	5.7 liters	6.0 quarts
Transmission Fluid
Valve Body Cover Removal (6T40/45/50)	5.0-7.0 liters	5.3-7.4 quarts
Valve Body Cover Removal (6T70)	5.0-7.0 liters	5.3-7.4 quarts
Fluid Change - Drain Plug (6T40/45/50)	4.0-6.0 liters	4.2-5.3 quarts
Fluid Change - Drain Plug (6T70)	4.0-6.0 liters	4.2-5.3 quarts
Overhaul (6T40/45/50)	8.0-8.5 liters	8.5-9.0 quarts
Overhaul (6T70)	7.0-9.0 liters	7.4-9.5 quarts
Transfer Case	0.66 liters	0.69 quarts
Hydraulic Brake System	0.464 liters	0.981 pints
Abrupt Refrigerant Loss	60 ml¹	2.0 oz¹
Compressor Replacement
NOTE: Compressor failure can occur if the oil removed during refrigerant recovery is not replaced. The service compressor is shipped with 74 ml² (2.5 oz² ) or 40 ml² (1.4 oz² ) of PAG oil. Refer to the oil balance instructions for information regarding the specific service compressor oil charge.
Condenser Replacement	30 ml²	1.0 oz²
Evaporator Replacement	90 ml²	3.0 oz²
Any Line Set (Hose/Tube or Tube Assembly) Replacement	30 ml²	1.0 oz²
Total System PAG Oil Capacity	110.0 ml	3.7 oz
R-134a
Refrigerant Charge -LAF/LEA/LF1/LLT/LUK/LFX	0.68 kg	1.50 lb
Refrigerant Charge - LHU	0.60 kg	1.30 lb
¹ Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component. ² If more than the specified amount of PAG oil was drained from a component, add the amount drained.