LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  4. Clean the wheel speed sensor mounting area on the suspension knuckle of any accumulated dirt and debris.
    5. Fig 1: Shock Absorber Electrical Connector
    GM2330163Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the shock absorber electrical connector (1), if equipped.
    6. Fig 2: Wheel Speed Sensor Harness Clips And Rear Suspension Bracket
    GM2330165Courtesy of GENERAL MOTORS COMPANY
  6. Release the wheel speed sensor harness clips (1) from the rear suspension bracket.
  7. Disconnect the wheel speed sensor harness electrical connector.
    8. Fig 3: Wheel Speed Sensor Bolt
    GM2330166Courtesy of GENERAL MOTORS COMPANY
  8. Remove the wheel speed sensor bolt (1).
  9. Remove the wheel speed sensor from the rear suspension knuckle.
scientia non olet · About LEMON Manuals