LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1992 >> Roadmaster Base >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Door Trim Panel >> Removal

Door Trim Panel: Removal

  1. Remove negative battery cable.
  2. Insert screw driver in outward slots to disengage tabs. Remove armrest switch plate (3), (if equipped). See Figure .
  3. Disconnect power window connector from armrest switch plate (3).
  4. Disconnect power seat connector from armrest switch plate (3), if equipped.
  5. Remove screw (8) connecting bezel assembly (7) to door trim panel (2) and unsnap bezel assembly to remove. See Figure .
  6. Twist side window switch floodlamp 90 degrees to remove (if equipped).
  7. Loosen setscrew (5) connecting mirror control knob (4) to bezel assembly (7) and remove control knob (4). See Figure .
  8. Disconnect power door lock connector from power door lock switch, if equipped.
  9. Remove screws underneath pull handle.
  10. Remove inside pull strap handle. See PULL HANDLE  .
  11. Remove armrest. See ARMREST  .
  12. Remove door panel screw (127), located between armrest and map pocket opening (front door) or below rear edge of carpeted section (rear door). See Figure .
  13. Disengage clips and disconnect electrical connection to remove courtesy lamp assembly or courtesy lamp cover from door trim panel (2), if equipped.
  14. Remove door trim panel (2) using Tool (J 24595-C). See SPECIAL TOOLS  .
scientia non olet · About LEMON Manuals