Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | TECHNICAL DATA | ||
| Torque | REFRIGERANT CIRCUIT | ||
| Axle Nut/Hub Nut | |||
| Front | 200 Nm +180° | ||
| Rear | 200 Nm +180° | ||
| Battery | OVERVIEW - BATTERY | ||
| Brakes | |||
| Bleeding Sequence | HYDRAULIC SYSTEM, BLEEDING WITH BRAKE CHARGER/BLEEDING UNIT HYDRAULIC SYSTEM, BLEEDING WITHOUT BRAKE CHARGER/BLEEDER UNIT |
||
| Disc Brakes | PR NUMBER ALLOCATION - BRAKES | ||
| Torque | OVERVIEW - FRONT BRAKE CALIPER
or OVERVIEW - REAR BRAKE CALIPER
Hydraulic Components OVERVIEW - FRONT BRAKES or OVERVIEW - REAR BRAKES Mechanical Components |
||
| Charging | |||
| Generator | N/A | ||
| Torque | |||
| Drive Belts | |||
| Adjustment | |||
| 2.0L | RIBBED BELT, REMOVING AND INSTALLING | ||
| Belt Routing | |||
| 2.0L | OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | |||
| 2.0L | 1.4 to 1.6 bar (20.30 to 23.20 psi) | ||
| Thermostat R & I | |||
| 2.0L | OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT | ||
| Water Pump R & I | |||
| 2.0L | OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT | ||
| Engine Mechanical | |||
| 2.0L | |||
| Compression | COMPRESSION, CHECKING | ||
| Oil Pressure | Oil pressure at idle: 1.2 to 2.0 bar positive pressure. Oil pressure at 2000 RPM: 1.6 to 2.2 bar positive pressure. Oil pressure at 3700 RPM: 3.0 to 4.0 bar positive pressure. During the break-in phase, the oil pressure may be at 2000/min at 3.0 to 4.0 bar. |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | Refer to the appropriate Engine article | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Engine Oil Pan Drain Plug | 30 Nm | ||
| Flywheel/Flex Plate Torque | 60 Nm + 90° | ||
| Fuel System | |||
| Pressure Specification | |||
| 2.0L | The fuel injection system is separated into a high-pressure section (maximum approximately 140 bar) and a low-pressure section (approximately 7 bar). | ||
| Fuel Pressure Test Procedure | |||
| 2.0L | FUEL PRESSURE SENSOR -G247-, CHECKING | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | |||
| 2.0L | TEST DATA | ||
| Starting | |||
| Starter | N/A | ||
| Torque | OVERVIEW - STARTER | ||
| Wheel Alignment | |||
| Adjustment Specifications | AXLE ALIGNMENT SPECIFIED VALUES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
Front FASTENER TIGHTENING SPECIFICATIONS Rear |
||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 120 Nm | ||