Speech Input Control Module -J507- Through 10.31.2008

WARNING: This page is about a different variant/trim than selected.

The speech input control module is located in the radio (MMI) behind the luggage compartment left side trim.

-- Turn off all electrical consumers.

-- Remove the key.

-- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Removal and Installation.

Removing

-- Remove the radio (MMI). Refer to RADIO, MMI THROUGH 10.31.2008 .

-- Open cover -2- of radio and fold it down -arrow-.

Fig 1: Identifying Radio R Cover And Speech Input Control Module J507

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pull the speech input control module -1- out of the radio in the -direction of the arrow-.

Installing

-- Install in reverse order of removal.

-- Make sure that harness connector between speech input control module and the radio engages correctly in the radio.

Perform the following function test:

-- Switch on the radio.

-- Briefly depress PTT button on multifunction steering wheel.

A "Ping" tone sounds, the speech input system is active.

-- Say "Help".

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

-- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

-- Press and hold the PPT button for approximately one second.

The speech dialog system responds with "Cancel" and is deactivated.