LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Communication (AVANT)) >> 91 Communication >> Removal And Installation >> Rearview Camera System Control Module -J772-

Rearview Camera System Control Module -J772-

WARNING: This page is about a different variant/trim than selected.

The rearview camera system control module is located behind the luggage compartment right side trim.

-- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Vehicle Diagnostic Tester.

-- Turn off all electrical consumers.

-- Remove the key.

Removing 

-- Remove the right luggage compartment trim panel. Refer to Removal and Installation .

The rearview camera system control module -3- is wedged into the bracket -2-.

Fig 1: Identifying Rearview Camera System Control Module Is Wedged Into Bracket, Removal
GWWA91-10979Courtesy of AUDI OF AMERICA, LLC

Remove the Comfort System Central Control Module -J393- -1- first, and then the bracket -2-.

-- Remove the screws -arrows- and nuts -5-.

-- Remove the bracket -2- from the storage compartment in order to disconnect the connectors -3- and -4-.

Fig 2: Identifying Bracket From Storage Compartment In Order To Disconnect Connectors, Removal
GWWA91-10979Courtesy of AUDI OF AMERICA, LLC

-- Unclip the rearview camera system control module out of the bracket -2- and remove it upward.

-- Unlock and disconnect the connector from the rearview camera system control module.

Installing 

-- Install in reverse order of removal.

-- Perform a calibration, refer to REARVIEW CAMERA SYSTEM, CALIBRATING .