LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Communication (AVANT)) >> 91 Communication >> Removal And Installation >> Internet Access Control Module -J666-, From My 13 >> Internet Access Control Module -J666-

Internet Access Control Module -J666-

WARNING: This page is about a different variant/trim than selected.

The internet access control module -1- is located in the glove compartment -2-.

Fig 1: Identifying Internet Access Control Module
GWWA91-11928Courtesy of AUDI OF AMERICA, LLC

-- Turn off all electrical consumers.

-- Remove the key.

Removing 

-- Open the glove compartment.

-- Remove the chip card.

-- Slide the internet access control module -1- in the -direction of the arrow- until it can be removed from the trim -2-.

Fig 2: Identifying Internet Access Control Module
GWWA91-11928Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -3- from the chip card reader control module -J676- -1-.

Installing 

-- Install in reverse order of removal.

-- Peel off the protective backing from the internal battery.

If the internet access control module is replaced, the consumer must re-configure it again.