Front Information Display Control Head Control Module -J523-, MMI Basic

Special tools and workshop equipment required 

• Radio Removal Tool T10057
• Protective Cap For Cable Connector VAS 6223/9

The Front Information Display Control Head Control Module is located in the glove compartment.

-- Turn off all electrical consumers.

-- Remove the key.

-- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Vehicle Diagnostic Tester.

Removing 

-- Open the glove compartment.

-- Insert two hooks of T10057 into the release slits on the Front Information Display Control Head Control Module until they engage. Points on the grip eyelets of tool face outward.

Fig 1: Inserting Two Clips Of T10057 Into Release Slots Of Navigation System With Cd Drive Control Module Until They Engage

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Front Information Display Control Head Control Module from the mounting frame.

-- Pull T10057 out while pressing on locking tabs on the Front Information Display Control Head Control Module.

-- Release and disconnect the connectors from the Front Information Display Control Head Control Module.

-- Connect the VAS 6223/9 -1- to the connector for the MOST-Bus -2-.

Fig 2: Identifying Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

Installing 

-- Connect all harness connectors.

-- Slide Front Information Display Control Head Control Module into installation frame until it engages.