LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A4 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Communication (AVANT)) >> 91 Communication >> Removal And Installation >> External Audio Source Connection -R199-, Interface

External Audio Source Connection -R199-, Interface

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required 

The external audio source connection (interface) -1- is located inside the glove compartment.

Fig 1: Identifying External Audio Source Connection (Interface) (Located Inside Glove Compartment)
GWWA91-11784Courtesy of AUDI OF AMERICA, LLC

-- Turn off all electrical consumers.

-- Turn off the ignition and remove the key.

Removing 

The wires for the interface are components of the wiring harness. They cannot be replaced separately. If faulty, the adapter cable must be installed.

-- Open the glove compartment.

-- Remove the trim -1- using the VAS 3409.

Fig 2: Identifying Trim Using VAS 3409, Removal
GWWA91-11784Courtesy of AUDI OF AMERICA, LLC

The interface (T30b) -1- is installed from behind in the glove compartment -2-.

Fig 3: Identifying Interface (T30B) (Installed From Behind In Glove Compartment)
GWWA91-11925Courtesy of AUDI OF AMERICA, LLC

The connectors for the interface T4ap -1- and T12y -2- are found on the Information electronics control module 1 -J794-.

Fig 4: Identifying Connectors From Interface (Found On Information Electronics Control Module)
GWWA91-11787Courtesy of AUDI OF AMERICA, LLC

Installing 

-- Install in reverse order of removal.