Emblem/Sticker Replacement: Notes
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Acura Tool and Equipment Program; call 888-424-6857
NOTE:
- When removing the emblems, take care not to scratch the body or the lower rear window.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Do not use any metallic tools to remove the rear "A" emblem.
- To remove the front "A" emblem, remove the front grille emblem base (see MOLDING REPLACEMENT ).
- Clean the body surfaces or the lower rear window surface where emblems are applied with a shop towel dampened with isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the clean surface.
- Before applying the rear "A" emblem to the lower rear window, apply glass primer to the double-sided adhesive tape on the emblem and leave the emblem for at least 10 minutes at 73°F ± 2°F (23°C ± 2°C) and 65%rh (± 15%rh) condition, then apply the emblem to the window in less than 12 hours.
- Before applying the rear "A" emblem to the lower rear window, keep the window temperature over 59°F (15°C) for at least an hour.
- Apply the emblems where shown. Push on the emblems to make the adhesive stick securely.