SH-AWD Control Unit Initialization

Whenever the SH-AWD control unit is replaced, it must be initialized

1. With the ignition switch in LOCK (0), or the vehicle in the OFF mode, connect the HDS to the DLC (A) located under the driver's side of the dashboard
   Fig 1: Identifying HDS To DLC Location

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
3. Make sure the HDS communicates with the vehicle and the SH-AWD control unit If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING )
4. From the mode menu, select SH-AWD, select MISCELLANEOUS TEST, then select INITIALIZATION with the HDS, and follow the screen prompts