Power Mirror Actuator Replacement

Remove the mirror holder (see MIRROR HOLDER REPLACEMENT ).
Remove the power mirror (see POWER MIRROR REPLACEMENT ).
Disconnect the 8P connector from the mirror.
Record the terminal locations and wire colors.
Disassemble the power mirror 8P connector, and remove all terminals from it.

Fig 1: Identifying Power Mirror 8P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws and the mirror visor (A).

Fig 2: Identifying Mirror Visor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screw from the gasket (A).

Fig 3: Identifying Mirror Visor Gasket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the three screws, and separate the mirror housing (A) from the bracket (B).

Fig 4: Identifying Mirror Housing Bracket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the four screws, and the actuator (A).

Fig 5: Identifying Actuator 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 2P connector (B) from the side turn signal light.
Route the wire harness (A) of the new actuator through the hole in the bracket (B) and gasket (C).

Fig 6: Identifying Actuator Wire Harness And Gasket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the actuator, bracket, harness clip, and gasket in the reverse order of removal.
Insert the new actuator terminals into the connector in the original arrangement.
Left:

Fig 7: Identifying Actuator Connector Terminals - Left
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Right:

Fig 8: Identifying Actuator Connector Terminals - Right
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Apply tape to seal the intersection of the wire harness and the gasket.
Reassemble in the reverse order of disassembly. Be careful not to break the mirror when reinstalling it to the actuator.
Reinstall the mirror assembly on the door.
Operate the power mirror to ensure smooth operation.