A/T Gear Position Indicator

Remove instrument panel gauge assembly from instrument panel. Disconnect 22-pin and 30-pin connectors from rear of instrument panel gauge assembly.
Inspect and repair as necessary any loose, corroded or bent terminals. Check for voltage and continuity at electrical connectors as specified. See Fig 2 .
Repair any circuit were specifications are outside desired result. If all tests are okay and A/T gear position indicator is defective, replace printed circuit board.

Fig 1: Identifying Ground Connections

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Testing A/T Gear Position Indicator

Courtesy of AMERICAN HONDA MOTOR CO., INC.

NOTE: For interlock system testing, see DTC FLOW CHARTS and wiring schematic. See Figure .